Kenwood eXcelon KDC-X789 - Audio Preset Recall and Demonstration Mode; Audio Preset Call Function; Demonstration Mode Settings

50
|
English
Menu system
Function of the KDC-MP7028/KDC-MP728/KDC-
X789/KDC-MP628
Other than Standby mode
Audio Preset Call
Recalling the sound setup registered by <Audio
Preset Memory> (page 49).
1 Select the source
Press the [SRC] button.
2 Enter Menu mode
Press the [MENU] button for at least 1 second.
"Menu" is displayed.
3 Select Audio Preset mode
Push the Control knob to [FM] or [AM].
Select the "Audio Preset" display.
4 Enter Audio Preset mode
Press the Control knob for at least 1 second.
5 Select the Audio Preset Call
Push the Contol knob to [FM] or [AM].
Select the "Call" display.
6 Call up the Audio Preset
Press the Control knob for at least 2 seconds.
The "Call" display blinks 1 time.
7 Exit Menu mode
Press the [MENU] button.
• The User memory of <Equalizer Control> (page 16) is
changed to the value which was recalled.
• The source tone memory item of <Audio Control>
(page 10) is changed to the value which was recalled
by the selected source.
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1 Select the Demonstration mode
Push the Control knob to [FM] or [AM].
Select the "DEMO Mode" display.
2 Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time the knob is pressed at least 2 seconds,
the Demonstration mode switches as shown
below.
Display Setting
"DEMO Mode : ON" The Demonstration mode function is ON.
"DEMO Mode : OFF" Exit Demonstration mode (Normal mode).
B64-2962-00Kr4English.Indd50B64-2962-00Kr4English.Indd50 04.11.1111:30:53AM04.11.1111:30:53AM