KERN DBS 60-3 User Manual

DBS-BA-e-1311 27
If the air bubble is at the lefthand edge, level the equipment with the righthand foot
screw, see Fig.1.
If the air bubble is at the righthand edge, level the equipment with the lefthand foot
screw, see Fig.2.
If both foot screws are turned simultaneously in clockwise direction, the air bubble will
move forwards (see Fig.3).
If both foot screws are turned simultaneously in anticlockwise direction, the air bubble will
move backwards (see Fig.4).
Check levelling regularly.
Fig. 1
Fig. 2
Fig. 3
Fig. 4

KERN DBS 60-3 Specifications

General

Category	Moisture Analyzer
Readability [d]	0.001 g
Reproducibility at 2g sample	0.2%
Reproducibility at 10g sample	0.05%
Minimum sample weight	0.5 g
Maximum sample weight	60 g
Heating type	Halogen
Drying time display	Yes
Halogen quartz glass heater	Yes
Power supply	220 V - 240 V AC, 50 Hz
Weighing range	60 g
Readability	0.001 g
Material	Stainless steel
Interface	RS 232
Heating programs	Standard
Switch-off criteria	Automatic, manual
Overall dimensions	202 x 336 x 157 mm
Net weight	4.2 kg
Temperature range	50 °C - 200 °C

Summary

Technical Data

Appliance Overview

Overview of Display

Keyboard Overview

Basic Information (General)

Proper Use

Guidelines for the intended and correct application of the moisture analyzer.

Improper Use

Identifies actions and conditions that constitute incorrect usage of the device.

Danger Information

Critical safety warnings and potential hazards associated with the appliance's operation.

Hazard Information Sticker

Explains specific hazard symbols and warnings found on the appliance.

Unpacking, Setup and Commissioning

Mains Connection

How to safely connect the appliance to the power supply.

Turning On the Power

Adjustment

Adjust Balance

Step-by-step guide to calibrate the balance for accurate measurements.

Adjust Temperature

Instructions for calibrating the temperature measurement functionality.

Moisture Analysis

Start Drying

Step-by-step guide to initiate a drying process for sample analysis.

Drying Parameters

Save / Access

Adjust

Adjusting drying modes and their associated parameters.

Drying Modes

Details on different drying modes (AUTO, TIME, RAPID, SLOW, STEP).

Drying Mode AUTO

Configuration for the automatic drying mode with Delta M criterion.

Drying Mode TIME

Configuration for time-controlled drying mode.

RAPID Drying Mode

Settings and usage for the rapid drying mode with preheating.

SLOW Drying Mode

Configuration for the slow drying mode, suitable for heat-sensitive samples.

STEP Drying Mode

How to set up and use the step-by-step drying process.

Result Display

Start Criterion

Print, Store and Call-up Measurement Results

General Information Concerning Moisture Analysis

Preparing a Sample

Detailed instructions on how to prepare samples for accurate analysis.

Service, Maintenance, Disposal

Cleaning

Instructions on how to clean the different parts of the moisture analyzer.

Service, Maintenance

Remove Protective Glass Guard

Lamp Change

Replacing Fuses

Instant Help

Error Messages

Explanations of error codes and their corresponding remedies.