19
EN
breaker device with a contact gap allowing complete
disconnection in the conditions specied by class III
overvoltage;
use unions with IP55 or higher protection when connec
-
ting hoses, pipes or cable glands;
the electrical system upstream of the automation sy
-
stem must comply with the relevant regulations and be
constructed to good workmanship standards;
this appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or in
-
struction concerning use of the appliance in a safe way
and understand the hazards involved;
before starting the automation system, ensure that the
-
re is no-one in the immediate vicinity;
before proceeding with any cleaning or maintenance
work on the automation system, disconnect it from the
electrical mains;
special care must be taken to avoid crushing between
the part operated by the automation system and any
xed parts around it;
children must be supervised to ensure that they do not
play with the equipment;
that the drive cannot be used with a driven part incorpo
-
rating a wicket door unless the drive can only be opera-
ted with the wicket door in the safe position;
install any xed control at a height of at least 1,5m and
within sight of the door but away from moving parts;
after installation, ensure that parts of the door do not
extend over public footpaths or roads;
when the appliance is provided with a separate stop
button, that stop button shall be unambiguously iden
-
tiable;
install the automation exclusively on gates operating on
at surfaces, that is, they are not installed on an up or
down tilt;
install exclusively on gates that are sturdy enough and
suitable to withstand the loads generated by the auto
-
mation itself;
do not subject the automation to direct jets of water,
such as sprinklers or pressure washers;
if the automation system exceeds 20 kg in weight, it
must be handled using safety lifting devices (IEC
60335-2-103: 2015);
provide appropriate safety protections in order to avoid
crushing and becoming trapped between the moving
guided part and any surrounding xed elements;
make sure that any protection or safety devices, in addi
-
tion to the manual release, work correctly;
place the automation identication plate at a clearly vi
-
sible point;
keep the manuals and technical les of all the devices
used to create the automation;
at the end of the automation installation it is advisable to
hand over the manuals relating to the warnings intended
for the end user;
ATTENTION !
Frequently examine the installation for imbalance
where applicable and signs of wear or damage to
cables, springs and mounting. Do not use the auto
-
mation if repair or adjustment is necessary.
ATTENTION !
The automation system component packaging ma-
terial must be disposed of in full observance of cur-
rent local waste disposal legislation.
Key Automation reserves the right to amend these in-
structions if necessary; they and/or any more recent
versions are available at www.keyautomation.com
To Next Page
Loading...
Need help?
General
