Key Automation CT10324 User Manual

4.5.2 DELETING A BUTTON OF A REMOTE CONTROL
If you are in programming mode, press the (MENU) button to exit until ready appears. Press the
(DOWN-RADIO) button for more than 2 seconds. Until the display shows the word
radio menu ’ (radio), then
release the button
1. Press and hold the (DOWN-RADIO) button until the LED lights up (about 3 seconds), then release the
button.
►
2. Within 7 seconds press the button of the remote control to be deleted, holding it down until the KEY LED goes
out. Release the remote control button
►
3. About 1 second after the button is released, the KEY LED starts to ash
(1s) + (1s) +
4. Conrm the deletion by pressing the (DOWN-RADIO) button
5. If the deletion of the button has been successful, KEY LED will give one long ash
3s
N.B If no commands are given for 7 seconds, the receiver automatically quits the programming mode
WARNING! If the transmitter you wish to delete was originally stored using the
LEARN ALL output (see chapter 4.5.1, phase 1), the
deletion procedure mentioned above will erase all functions associated with the buttons of that transmitter.
4.5.3 CLEARING THE ENTIRE RECEIVER MEMORY
If you are in programming mode, press the (MENU) button to exit until ready appears. Press the
(DOWN-RADIO) button for more than 2 seconds. Until the display shows the word
radio menu ’ (radio), then
release the button
1. Press the (DOWN-RADIO) button and hold it down until the LED lights up (about 3 seconds) and then goes
out (about 3 seconds). Release the button.
(>3s)-> (>3s)->
2. About 1 second after the button is released, the KEY LED starts to ash
(1s)+ (1s)+
3. Press the (DOWN-RADIO) button as the LED ashes for the third time
4. If the deletion has been successful, the KEY LED will give one long ash
3s
26
EN
The default procedure will reset the system to the factory settings and, if necessary, will allow to change the motor type.
To proceed, enter the ADVANCED MENU: press and hold for 5 sec. the
(MENU) button. Scroll the menu with (UP) (DOWN-RADIO)
until
motor SETUP appears. Press the (MENU) button for 1 sec. to see the type of motor selected
ATTENTION! ONLY if you need to change the type of motor, change the number with (UP) or (DOWN)
Press and hold the
(MENU) button, a countdown starts: 49, 48, …, 1 until DONE appears. Release the button.
If necessary, users may select a BASIC MENU which allows modi-
cation of the control unit’s basic parameters. To select the BASIC
MENU proceed as described below.
ATTENTION !
To be sure of accessing the NORMAL OPERATION display
state, the starting point for accessing the BASIC MENU, press
the
(MENU) button twice.
Exampling of modifying a BASIC MENU parameter:
After accessing the BASIC
MENU, press the
(UP)
and
(DOWN) button to
scroll through the functions.
Press the
(MENU) button
and hold it down to access the
BASIC MENU.
Press the
or buttons to
to modify the value.
To access the value modi-
cation function, press the
(MENU) button for 1 second,
until the value starts to ash
quickly.
ready
auto close
4.6 - Default procedure
4.7 - Customising the system - Basic menu

Key Automation CT10324 Specifications

General

Brand	Key Automation
Model	CT10324
Category	Control Unit
Language	English