2-4 Configuring Communication with the DL-EP1
2-11
2
Connection and Configuration
- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (GT2) -
To display "Not Set" for the IP address, the network status indicator
(NS) must be off (IP address not assigned). To unassign the IP
address, hold down the Reset switch on the DL-EP1 for three
seconds or longer.
2
Select the device for which to set the IP address and click [Setup IP addr.(I)] to
display [Setup IP addr.].
Compare the MAC address to be displayed with the front MAC address on the
DL-EP1 and select the device for which to set the IP address.
Set an IP address which is not currently used in "IP addr.(required)(I)" and click
the [OK] button.
Using the [Search available IP addresses (F)] button enables you to
search for open IP addresses.
Point
To Next Page
Loading...
Need help?
General