Keysight Technologies 11713D - Page 18

1Introduction
18 Keysight 11713D/E Operating and Service Manual
For the configuration details, refer to Keysight 11713D/E Configuration Guide available at
www.keysight.com/find/11713.
Table 1-4 Connecting accessories for Keysight 11713D/E
Connecting accessories Description
11716A
Interconnect kit (Type-N connectors)
[a]
[a] Order this kit to connect two programmable step attenuators in series
11716C
Interconnect kit (SMA connectors)
[a]
11713D-102 11713-60068, Viking connector to 4 cables with 4-conductor bare wires
11713D-103 11713-60069, Viking connector to 2 cables with 5-conductor bare wires
11713D-104 11713-60071, Viking connector to 4 cables with 3-pin connector
11713D-105 11713-60072, Viking connector to 4 cables with 3-conductor bare wires
11713D-001
11713E-001
11764-60004, Viking connector to 10-pin DIP connector, 60 inches long
11713D-101
11713E-101
8120-2703, Viking connector to Viking connector, 60 inches long
11713D-201
11713E-201
5061-0969, Viking connector to 12-pin conductor cable, bare wire (for five switches), 60
inches long
11713D-301
11713E-301
11761-60001, Viking connector to (4) ribbon cables, connect up to four switches, 60
inches long
11713D-401
11713E-401
11713-60042, dual Viking connector to 16-pin DIP connector, 60 inches long
11713D-501
11713E-501
11713-60043, Viking connector to (4) 9-pin Dsub connectors, connect up to four
switches, 60 inches long
11713D-601
11713E-601
11713-60044, Viking connector to 16-pin DIP connector, 60 inches long
11713D-701
11713E-701
5064-7848, Viking connector to 14-pin DIP connector, 60 inches long
11713D-801
11713E-801
11713-60047, Viking connector to (4) 10-pin DIP connectors, connect up to 4 switches,
50 inches long
11713D-908
11713E-908
1CM124A, rack mount kit for one instrument
11713D-909
11713E-909
5061-9694 & 1CM107A, rack mount kit for two instruments