Keysight Technologies 11713D - Connecting to Keysight Attenuators and Switches

2Installation
28 Keysight 11713D/E Operating and Service Manual
Connecting to Keysight Attenuators and Switches
The 11713D/E attenuator/switch drivers can be used to drive various switches and attenuators.
Table 2-1 shows the summary of switches and attenuators connections to the 11713D/E, with
various interface cables for point-to-point connection. Table 2-2 shows the properties of 11713D/
E’s front panel and rear panel.
For the configuration details, refer to Keysight 11713D/E Configuration Guide available at
www.keysight.com/find/11713.
Table 2-1 Summary of switches and attenuators connections to 11713D/E
Switches/attenuators
11713D/E cable
option
[a]
# of channels
required
[b]
Controlled by
ATTEN X (1-4)
ATTEN Y (5-8)
Controlled by
SWITCHES (9/0)
Switches
– 8762A/B/C/F
– 8763A/B/C
– 8764A/B/C
201 2 Yes Yes
Switches
– 8765A/B/C/D/F
201, 301 2 Yes Yes
Switches
– 8766K
001, 101 2 Yes Yes
Switches
– N1810UL/TL
[c]
– N1811TL
[c]
– N1812UL
[c]
201, 501 2 Yes Yes
Switches
– 87222C/D/E
– L7222C
201, 801 2 Yes No
Switches
– 8767K
Attenuators
– 8495G/H
001, 101 3 Yes Yes
Switches
– 8767M
Attenuators
– 84905M
– 84907K/L
001 3 Yes Yes
Switches
– 8768K
Attenuators
– 8494G/H
– 8496G/H
– 8495K, 8497K
001, 101 4 Yes Yes