Keysight Technologies 11713D - Page 29

Installation 2
Keysight 11713D/E Operating and Service Manual 29
Switches
– 8768M
Attenuators
– 84904K/L/M
– 84906K/L
– 84908M
001 4 Yes Yes
Switches
[d]
– 87104A/B/C/D
– 87204A/B/C
– L7104A/B/C
– L7204A/B/C
201, 601
4
[e]
Yes Yes
Switches
– 8769K
101 5 Yes Yes
Switches
– 8769M
701 5 Yes Yes
Switches
– 87106A/B/C/D
– 87206A/B/C
– L7106A/B/C
– L7206A/B/C
– 87406B, 87606B
201, 401
6
[f]
Yes Yes
Switches
- U9397A/C
105 1 Yes No
Switches
- U9400A/C
104 1 Yes No
Switches
- P9400A/C
102 1 Yes No
Switches
- P9402A/C
103 2 Yes No
Switches
- P9404A/C
201 4 Yes No
[a] Type of interface cable required depends on the DC connector on the switching device
[b] One channel represent control with one pushbutton
[c] Ensure switch is equipped with current interrupt (option 403) to protect switch from overheating and destruction as this switch cannot
withstand continuous current
[d] For switches with option 161, ground pin 16 opens all path. Use S9 for Attenuator X or S0 for Attenuator Y. Do not close any path and
ground pin 16 simultaneously as this makes the switch buzz.
[e] If option 601 is used, number of channels required is 5, to cater for open all path function controlled via S9/S0
[f] If option 401 is used, number of channels required is 7, to cater for open all path function controlled via S9/S0
Table 2-1 Summary of switches and attenuators connections to 11713D/E (continued)
Switches/attenuators
11713D/E cable
option
[a]
# of channels
required
[b]
Controlled by
ATTEN X (1-4)
ATTEN Y (5-8)
Controlled by
SWITCHES (9/0)