1Introduction
22 Keysight 11713D/E Operating and Service Manual
13 Attenuator Y for Bank 2: In the local mode, pushbuttons 5, 6, 7, and 8 change the attenuation
setting of an attenuator or change the position of coaxial switch(es) connected to the ATTEN Y
connector on the rear panel, for bank 2.
14 Attenuator X for Bank 1: In the local mode, pushbuttons 1, 2, 3, and 4 change the attenuation
setting of an attenuator or change the position of coaxial switch(es) connected to the ATTEN X
connector on the rear panel, for bank 1.
15 Attenuator X for Bank 2: In the local mode, pushbuttons 1, 2, 3, and 4 change the attenuation
setting of an attenuator or change the position of coaxial switch(es) connected to the ATTEN X
connector on the rear panel, for bank 2.
16 On/Standby: Press this key to switch between on and standby. When power is supplied, the
background LED is red. Pressing the key once switches the driver on and the background LED
turns to green.
17 Local: Press this key to control the driver from the front panel when it is operating via the
remote interfaces.
To Next Page
Loading...
