Keysight Technologies 53150A - Page 85

Operating Your Frequency Counter 2
Keysight 53150A/151A/152A Operating Guide 85
3 Use the left- and right-arrow keys to move the focus to the digit(s) in the
frequency-offset display that you need to adjust to enter the offset value, and
then use the up- and down-arrow keys to adjust the value for each digit. Enter
a value of 500 Hz.
The flashing digit is the digit that currently has the focus. This means that you
can change the value of the flashing digit using the up- and down-arrow keys.
4 Press the sign (+/–) key (if desired) to change the sign of the offset value.
The display should look like this:
5 Press the Enter key to confirm the offset value and exit the
offset-entry display.
The Freq Offset annunciator is deactivated, and the measurement
display returns.
GHz
MHz
kHz
Hz
Ch 1
Rel
Freq
Offset
NOTE
When you are entering a value for Frequency Offset (or Power Offset),
you can use the Reset key to restore all of the displayed digits to zero. These are
the only two functions in which the Reset key has this effect.