Keysight Technologies E4360 Series User Manual

4 Series E4360 User’s Guide
Safety Notices
The following general safety
precautions must be observed during
all phases of operation of this
instrument. Failure to comply with
these precautions or with specific
warnings or instructions elsewhere in
this manual violates safety standards
of design, manufacture, and intended
use of the instrument. Keysight
Technologies assumes no liability for
the customer's failure to comply with
these requirements.
General
Do not use this product in any
manner not specified by the
manufacturer. The protective
features of this product may be
impaired if it is used in a manner not
specified in the operation
instructions.
Before Applying Power
Verify that all safety precautions are
taken. Make all connections to the
unit before applying power. Note the
instrument's external markings
described under "Safety Symbols"
Ground the Instrument
This product is a Safety Class 1
instrument (provided with a
protective earth terminal). To
minimize shock hazard, the
instrument chassis and cover must
be connected to an electrical ground.
The instrument must be connected to
the AC power mains through a
grounded power cable, with the
ground wire firmly connected to an
electrical ground (safety ground) at
the power outlet. Any interruption of
the protective (grounding) conductor
or disconnection of the protective
earth terminal will cause a potential
shock hazard that could result in
personal injury.
Fuses
Only fuses with required rated
current, voltage, and specified type
(normal blow, time delay, etc.) should
be used. Do not use repaired fuses or
short-circuited fuseholders. To do so
could cause a shock or fire hazard.
Do Not Operate in an
Explosive Atmosphere
Do not operate the instrument in the
presence of flammable gases or
fumes.
Do Not Remove the
Instrument Cover
Only qualified, service-trained
personnel who are aware of the
hazards involved should remove
instrument covers. Always
disconnect the power cable and any
external circuits before removing the
instrument cover.
Do Not Modify the Instrument
Do not install substitute parts or
perform any unauthorized
modification to the product. Return
the product to a Keysight Sales and
Service Office for service and repair
to ensure that safety features are
maintained.
In Case of Damage
Instruments that appear damaged or
defective should be made inoperative
and secured against unintended
operation until they can be repaired
by qualified service personnel.
A CAUTION notice denotes a hazard.
It calls attention to an operating
procedure, practice, or the like that,
if not correctly performed or adhered
to, could result in damage to the
product or loss of important data. Do
not proceed beyond a CAUTION
notice until the indicated conditions
are fully understood and met.
A WARNING notice denotes a
hazard. It calls attention to an
operating procedure, practice, or
the like that, if not correctly
performed or adhered to, could
result in personal injury or death.
Do not proceed beyond a
WARNING notice until the
indicated conditions are fully
understood and met.
Safety Symbols
Direct current
Alternating current
Both direct and
alternating
current
Three phase alternating
current
Earth (ground) terminal
Protective earth ground
terminal.
Frame or chassis
terminal
Terminal is at earth
potential.
Neutral conductor on
permanently installed
equipment
Line conductor on
permanently installed
equipment.
On supply
Off supply
Standby supply. Unit is
not completely
disconnected from AC
mains when switch is off
In position of a bi-stable
push switch
Out position of a bi-
stable push switch
Caution, risk of electric
shock
Caution, hot surface
Caution, refer to
accompanying
description
CAUTION
WARNING

Keysight Technologies E4360 Series Specifications

General

Brand	Keysight Technologies
Model	E4360 Series
Category	Switch
Language	English