Getting Started 3
Series E4360 User’s Guide 43
4 4 Enter
The command menu is now at the function control level. This is the lowest
level in this path.
Use the navigation keys to highlight the OVP Level control as shown below.
Enter the desired over-voltage level using the numeric keypad. Then press
Enter.
Press the
key at any time to select a different output channel. This
can save time because you can directly access the OVP control of each
channel without having to navigate through the menu levels.
NOTE
If you program an over-voltage protection level that is lower than the
present output voltage, the over-voltage protection circuit will trip and
turn the output channel off. The front panel status indicator will show
OV.
Exit the Command Menu
There are two ways to exit the command menu.
Press the Meter key to immediately return to the metering screen. This is the
quickest way to return to metering mode.
Back
Press the Back key to back up one level at a time in the command menu.
This method may be more convenient if there are other menu commands to
be given.
Detailed instructions on how to use the SAS functions and capabilities
are found in the next chapter. Detailed information about the SCPI
programming commands are found in the Programmer’s Reference Help
file on your Keysight 14360 System Control Tools CD.
In Case of Trouble
Press the Help key to obtain additional help about any function control
menu level. Press the Back key to exit the Help menu.
The front panel Err indicator comes on operating problems occur with
your instrument. Press the Error key to display the list of errors. Refer to
the Keysight E4360 Service Guide for further information.
The E4360 Service Guide is included as part of the optional Manual Set
(Option 0L1). An electronic copy of the E4360 Service Guide is also
included on the Keysight 14360 System Control Tools CD.
To Next Page
Loading...
Need help?
General
