Specifications and Application Information Appendix A
Series E4360 User’s Guide 89
Supplemental Characteristics (continued)
Regulatory Compliance
EMC:
Safety:
Complies with European EMC Directive for test and measurement
products.
● IEC/EN 61326-1
● CISPR 11, Group 1, class A
● AS/NZS CISPR 11
● ICES/NMB-001
Complies with Australian standard and carries C-Tick mark.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
Complies with European Low Voltage Directive and carries the CE-
marking.
Conforms to UL 61010-1 and CSA C22.2 61010-1.
Declarations of Conformity for this product and for other Keysight
products may be downloaded from the Web. Go to
http://www.keysight.com/go/conformity
and click on “Declarations of
Conformity.” You can then search by product number to find the latest
Declaration of Conformity
AC Mains
Input ratings:
Power consumption:
Power factor:
NOTE 1
AC line spike rating:
Fuse:
~ 100 VAC – 240 VAC; 50/60/400Hz
1440 VA (@ <, 180 VAC input for E4360A)
2200 VA (@ >, 180 VAC input for E4360A)
1440 VA (@100 VAC – 240 VAC input for E4360J01)
0.99 @ nominal input and rated power
1 kV typical
15A / 250 VAC non-time delay (Keysight p/n 2110-0054)
100-180 VAC Note: AC mains circuits rated at nominal 100-180 VAC cannot supply enough current to power the
E4360A mainframe when two output modules are installed. In this case, internal circuits will limit the output current of
the modules to one half of their rating. For a single installed module, full output current will be available at nominal
100-180 VAC. This restriction does not apply to mainframe Model E4360J01.
Height:
Width:
Depth including handles:
88.1 mm / 3.5 in. for E4360A
44.75 mm / 1.75 in for E4360J01
432.5 mm / 17.03 in.
633.9 mm / 24.96 in.
Net Weight
E4360A with 2 output modules:
E4360J01 with 2 output modules:
Single output module:
17
.6 kg / 38.4 lbs.
11.82 kg / 26 lbs
3.3 kg / 7.2 lbs.
1
Under full load at 400 Hz, power factor drops from 0.99 @ 120 VAC to as low as
0.76 @ 265 VAC. Power factor degrades further under no load conditions.
To Next Page
Loading...
Need help?
General
