Keysight E5061B Network Analyzers 29
Troubleshooting
Booting Process Troubleshooting
Step 3. Windows boot screens
The Windows boot screens are displayed. The Windows boot screens consists
of two screens. Each screen is displayed in the order as shown in Figure 2-10.
If the Windows boot screens are displayed, it is assumed that the HDD works.
While the Window screens are displayed, Windows operating system is
starting up.
Figure 2-10 Windows boot screens
If you encounter the following problems, try to reinstall the operating system
before replacing the HDD.
• "xxx file is missing" is displayed on DOS screen.
• The Window boot screen is not displayed after the splash screen is
displayed.
• Windows always boots up with Safe Mode.
If the E5061B was turned off without shutdown process, Microsoft
Scandisk runs while the windows boot screens are displayed. If a serious
problem is found in the scandisk, reinstall the operating system. For
details of the operating system installation, refer to Appendix B , “System
Recovery,” on page 113. If the operating system still doesn't boot up
properly after reinstallation, replace the HDD.
The operating system automatically checks the device drivers, which are
necessary to use the E5061B functions and are installed in the system
before the E5061B is shipped from Keysight factory. If the operating
system doesn't detect them, a message box is displayed. In this case,
install the device driver.
To Next Page
Loading...
Need help?
General
