Turning the Unit On
SHOCK HAZARD
Be aware that hazardous voltages can be present on the output terminals. Do not set the output voltage above
60 VDC when turning the unit on.
After you have connected the power cord, press the power switch to turn the unit on. The front panel display lights
up after a few seconds. When the front panel meter view appears, use the Voltage and Current knobs to enter
voltage and current values. Output 1 is selected by default.
Press one of the three [On] keys to enable an individual output. In meter view, the power supply continuously
measures and displays the output voltage and current of each output.
A power-on self-test occurs automatically when you turn the unit on. This assures you that the instrument is
operational. If self-test fails, or if other operating problems occur with your instrument, the front panel error
indicator ( ) appears at the upper top of the display.
Keysight EDU36311A User's Guide 39
To Next Page
Loading...
Need help?
General
