Keysight Technologies InfiniiVision 1000 X-Series User Manual

Getting Started 1
Keysight InfiniiVision 1000 X-Series Oscilloscopes User's Guide 17
Input a Waveform
The Probe Comp signal is used for compensating probes.
1 Connect an oscilloscope probe from channel 1 to the Demo, Probe Comp terminal
on the front panel.
2 Connect the probe's ground lead to the ground terminal (next to the Demo
terminal).
WARNING
A voltage source should never be connected to the ground terminal of this instrument.
If, for any reason, the Protective Conductor Terminal is disconnected or not functioning
properly and a voltage source is connected to the equipment's ground terminals, the
entire chassis will be at the voltage potential of the voltage source, and the operator or
bystanders could receive an electric shock.

Keysight Technologies InfiniiVision 1000 X-Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 1000 X-Series
Category	Test Equipment
Language	English