Keysight M8040A High-Performance BERT Getting Started Guide 33
Basic Setup for M8040A 2
Return the Damaged/Defective Item to Keysight for Repair/Replacement
If anything is missing, defective, or damaged,
1 Review the warranty information shipped with your product or check
the warranty information on Keysight website.
• To check the warranty information on your module, go to
www.keysight.com/find/warranty and specify the module’s model
number (for example, M8045A) in the Product Number field, and
specify the serial number from the top of the module in the Serial
Number field.
2 Contact the nearest Keysight Sales Office. If you need assistance
finding Keysight contact information, go to
www.keysight.com/find/assist (worldwide contact information for
repair and service).
Step 2 - Set up the M8040A
This step does not have to be performed while verifying the basic setup for
power up and connectivity. However, you will need to decide on a
benchtop or rack mounted usage of the M8040A after this basic
verification. For the procedures on how to set up the M8040A, refer to the
Installation Guide.
Step 3 - Set up the External Host Computer (not required for M8040A-BU1)
The host computer communicates with the ESM and instrument modules
in the chassis and hosts all the software components needed to use the
instrument modules.
Perform this step if you are using a laptop or desktop computer as the
host computer.
To Next Page
Loading...
Need help?
General
