66 Keysight M8040A High-Performance BERT Getting Started Guide
3 Using the M8040A High-Performance BERT
Updating Software Components
Updated versions of the M8070A and module specific software
components are available on the Keysight website.
These software components are available as .EXE files. To download a
software upgrade:
1Go to http://www.keysight.com/find/m8070a
2Click the Technical Support tab.
3Click Drivers and Software.
4 Type the model number of the instrument module for which software
update is needed and click Find. Model number is located on the front
panel of the module.
5Click the Driver and Software link on the module page.
6 Download the required software update from the list of available
updates.
Contacting Keysight Service and Support
To locate a sales or a service office near you, go to
www.keysight.com/find/contactus
Quick Troubleshooting
This section lists the basic troubleshooting steps that you might find useful
while setting up the M8040A.
The chassis does not power up
f the chassis or a module does not appear to power up, check the
following:
• The circuit breakers at the rear of the chassis are set to the right, which
is the ON position.
• The AC power cords are connected to a working power source.
• The electrical circuits are not overloaded. Check the combined power
requirements of all equipment on the same circuit.
• There are no empty slots in the chassis. Leaving slots empty can
overheat the inserted modules, causing them to shut down.
To Next Page
Loading...
Need help?
General
