Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide 101
Service and Utility Menus
Boot Service Menu
-256, File name not found; /USER/PTRAIN/LAST
The instrument will correct these errors after the power is cycled again.
However, the instrument will not be able to recover from the following error by
itself:
-310, System error; Failed to start Application or CalTest harness
To recover from this error the instrument firmware will need to be reinstalled.
See Chapter 19, “Instrument Firmware and Operating System” for information
on how to reinstall the instrument firmware.
Since this function will erase all user files saved on the A4 Solid State Disk
Drive it should not be used unless it is necessary. If possible, backup the user
files to an external device before selecting this function.
Format SD Card
This will format the option 006 A3A1 Rear Panel SD Memory Card. The SD
memory card contains only user files, if the user has selected to save data in
this location.
When the instrument is restarted after performing this format the following
errors may be seen:
-315, Configuration memory lost; Persistent state checksum is bad. Using
factory defaults.
-256, File name not found; /USER/USERFLAT/LAST
-256, File name not found; /USER/PTRAIN/LAST
The instrument will correct these errors after the power is cycled again.
Since this function will erase all user files on the A3A1 Rear Panel SD Memory
Card it should not be used unless it is necessary. If possible, backup the user
files to an external device before selecting this function.
To Next Page
Loading...
Need help?
General
