SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
The graphic above shows an SA display with markers.
Carrier with 5 kHz frequency modulation and deviation of 1 kHz.
In this Chapter
“Frequency Range” on page 149
“Radio Standard” on page 151
“Channel Selection” on page 152
“Reverse Swap” on page 154
“Scale and Units” on page 154
“External Gain” on page 155
“Attenuation Control” on page 156
“Preamplifier Control (Opt 235)” on page 157
“Check for Compressed Measurements” on page 157
“Field Strength Measurements” on page 158
“Using the Antenna/Cable Editor” on page 160
“Source Tracking Offset and Offset Reversal” on page 162
“Tune & Listen (AM/FM)” on page 163
“Analog Demod (Requires CPU2)” on page 167
“Independent Source/Tracking Generator ” on page 179
“Resolution Bandwidth (Res BW)” on page 180
“Video Bandwidth (Video BW)” on page 181
“AF RBW (Audio-Frequency Resolution BW)” on page 182
“Sweep Type” on page 182
“IF Output” on page 183
“Sweep Acquisition” on page 185
“Very Long Sweep Times” on page 186
“Zero Span Measurements” on page 186
“Triggering” on page 188
“FFT Gating (Opt 238)” on page 192
“Single / Continuous / Restart” on page 194
“Points ” on page 194
Keysight N9938-90003 User's Guide
To Next Page
Loading...
