SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
See Also
“Trace Display States (SA Mode)” on page 194
“Average Type” on page 195
“Average Count” on page 196
“Alignments” on page 197
“RF Burst Amplitude Alignment” on page 202
“Detection Method” on page 204
“Display Line” on page 206
“Noise Marker” on page 207
“Band/Interval Power Marker” on page 207
“Frequency Counter at Marker” on page 208
“Audio Beep at Marker Power” on page 209
“Meas UNCAL Error” on page 210
“Old Data Indicator (*)” on page 210
“Radio Standards and Channel Measurements” on page 211
“Measurement Preset” on page 211
“Averaging” on page 211
“Traces” on page 212
“Channel Power (CHP)” on page 212
“How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option
307), and SA Mode (Option 233–Mixed Analyzers))” on page 222
“Spectrum Emission Mask (SEM) — (Requires CPU2, SA Mode Only)” on
page 234
“IQ Analysis (Requires Option 353, SA Mode Only)” on page 241
“Effective Isotropic Radiated Power (EIRP) – (Requires CPU2, SA Mode
Only)” on page 244
Interference Analyzer:
“Record/Playback (SA Option)” on page 464
“Waterfall Display” on page 463
“Record/Playback (SA Option)” on page 464
Keysight N9938-90003 User's Guide
To Next Page
Loading...
