System Settings
Run/Hold
“File Saving Naming Options” on page 695
“System Configuration” on page 700
“Options (Licensing)” on page 700
“GNSS (GPS+) and GPS” on page 701
“Frequency Reference Source” on page 707
“Variable Voltage Source (Opt. 309)” on page 708
“Security Level” on page 709
“Date and Time, Format, and Time Zone Settings” on page 710
“LAN Settings” on page 711
“Power ON” on page 713
“FieldFox Package Installer (N995xA, N996xA, and applies to:
N991xA/2xA/3xA units with serial number prefixes ≥5607)” on
page 714
“Date and Time, Format, and Time Zone Settings” on page 710
“Service Diagnostics” on page 716
See Also:
“Install the Lithium-Ion Battery” on page 28
“FieldFox High Temperature Protection” on page 30
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
— Continuous
—Hold
— is displayed while a single sweep occurs.
How to perform a single sweep while in Hold
—Press Sweep 3.
— Then choose one of the following:
Keysight N9938-90003 User's Guide
To Next Page
Loading...
