2 Operating Information
44 Keysight 3458A Assembly-Level Repair Manual
This is the command header for the trigger command. Notice the multimeter
automatically placed a space after the command header.
Selecting a parameter
For parameters that have a list of choices (non-numeric parameters), you can use
the up and down arrow keys to review the choices.
Press:
The display shows:
Press:
The display shows:
When using the up or down arrow keys, if you step past the last parameter choice,
a wraparound occurs to the other end of the menu. Suppose you want to suspend
triggering. Press the up or down arrow key until the display shows:
Press:
You have now changed the trigger event from auto (power-on state) to HOLD
which causes the multimeter to stop taking readings. (Triggering is discussed in
detail in Chapter 4.)
To Next Page
Loading...
