Operating Information 2
Keysight 3458A Assembly-Level Repair Manual 45
Default values
Most parameters have a default value. A default value is the value selected when
you execute a command but do not specify a value. For example, the default value
for the trigger parameter is SGL.
Press:
Press:
Notice that the multimeter takes one reading and then stops (after the single
trigger, the trigger event becomes HOLD regardless of the previously specified
trigger event). You can also enter-1 to select the default value.
Press:
The multimeter again takes a single reading and then stops.
Numeric parameters
Some commands use numeric parameters. A numeric parameter is the actual
value used by the multimeter. We will use the NPLC configuration key to
demonstrate numeric parameters.
Press:
This display shows:
To Next Page
Loading...
