Keysight 3458A - Page 46

2 Operating Information
46 Keysight 3458A Assembly-Level Repair Manual
Notice that if you press the up or down arrow key, no parameter choice is
displayed. This means there is no menu and you must enter a number. For
example.
Press:
You have now selected 1 power line cycle of integration time for the A/D
Converter. Integration time is the actual time that the A/D Converter measures
the input signal. (Integration time is discussed in detail in Chapter 3.)
Exponential parameters
You can also enter numeric parameters using exponential notation. For example.
Press:
You have now selected 0.1 power line cycles of integration time. At this point, you
should reset the multimeter to return the number of power line cycles to 10 by
pressing:
Multiple parameters
Many commands have more than one parameter. (Multiple parameters are
separated by commas.) We will use the NRDGS command, which has two
parameters, as an example of a command with multiple parameters.
Press:
The display shows:
1
Enter
NPLC
1
0
0
E
_
3
Enter
Reset
N Rdge/
Trig