Keysight E3632A - Page 141

Remote Interface Reference 3
Status Reporting Commands
E3632A User’s Guide 119
*ESE?
This command queries the Standard Event Enable register.
The power supply returns a decimal value which
corresponds to the binary- weighted sum of all bits in the
register.
*ESR?
This command queries the Standard Event register. The
power supply returns a decimal value which corresponds to
the binary- weighted sum of all bits in the register.
*OPC
This command sets the “Operation Complete” bit (bit 0) of
the Standard Event register after the command is executed.
*OPC?
This command returns 1 to the output buffer after the
command is executed.
*PSC {0|1}
(Power- on status clear.) This command clears the Status
Byte and the Standard Event register enable masks when
power is turned on (*PSC 1). When *PSC 0 is in effect, the
Status Byte and Standard Event register enable masks are
not cleared when power is turned on.
*PSC?
This command queries the power- on status clear setting. The
returned parameter is 0 (*PSC 0) or 1 (*PSC 1).
*SRE <enable value>
This command enables bits in the Status Byte Enable
register.