3 Remote Interface Reference
Status Reporting Commands
120 E3632A User’s Guide
*SRE?
This command queries the Status Byte Enable register. The
power supply returns a decimal value which corresponds to
the binary- weighted sum of all bits set in the enable
register.
*STB?
This command queries the Status Byte summary register.
The *STB? command is similar to a serial poll but it is
processed like any other instrument command. The *STB?
command returns the same result as a serial poll but the
Request Service bit (bit 6) is not cleared if a serial poll has
occurred.
*WAI
This command instructs the power supply to wait for all
pending operations to complete before executing any
additional commands over the interface. Used only in the
triggered mode.
To Next Page
Loading...
