XIV E3632A User’s Guide
Reading a query response 81
Selecting a trigger source 81
Power supply programming ranges 82
Using the APPLy Command 83
APPLy {<voltage>| DEF | MIN | MAX}[,{<current>| DEF | MIN
| MAX}] 83
APPLy? 84
Output Settings and Operation Commands 85
Triggering Commands 93
Trigger source choices 93
Triggering commands 95
System-Related Commands 96
Calibration Commands 102
RS-232 Interface Commands 106
SCPI Status Registers 107
What is an event register? 107
What is an enable register? 107
SCPI status system 108
The Questionable Status register 109
The Standard Event register 110
The Status Byte register 112
Using Service Request (SRQ) and Serial POLL 113
Using *STB? to read the Status Byte 114
Using the Message Available Bit (MAV) 114
To interrupt your bus controller using SRQ 115
To determine when a command sequence is completed 115
Using *OPC to signal when data is in the output buffer 116
Status Reporting Commands 117
Halting an Output in Progress 121
To Next Page
Loading...
