24 Keysight Infiniium 90000A Series Oscilloscopes User’s Guide
1 Setting Up the Oscilloscope
Turning On the Oscilloscope
Press the power/standby button in the lower left corner of the oscilloscope front
panel.
After a short initialization period, the oscilloscope display appears. The
oscilloscope is ready to use.
You can connect and disconnect probes and BNC cables while the oscilloscope is
turned on.
This oscilloscope does not exceed 80 dBa sound pressure level, which is
considered to be below the OSHA permissible exposure level.
Figure 9 Turning On the oscilloscope
Aux Out Aux Trig
power/standby
button
To Next Page
Loading...
