127
Keysight InfiniiVision 3000T X-Series Oscilloscopes
User's Guide
6 Reference Waveforms
To save a waveform to a reference waveform location / 127
To display a reference waveform / 128
To scale and position reference waveforms / 129
To adjust reference waveform skew / 129
To display reference waveform information / 130
To save/recall reference waveform files to/from a USB storage device / 130
Analog channel or math waveforms can be saved to one of two reference
waveform locations in the oscilloscope. Then, a reference waveform can be
displayed and compared against other waveforms. One reference waveform can
be displayed at a time.
When the multiplexed knobs are assigned to reference waveforms (this happens
when you press the [Ref] key and the LED to the left of it is lit), you can use the
knobs to scale and position reference waveforms. There is also a skew adjustment
for reference waveforms. Reference waveform scale, offset, and skew information
can optionally be included on the oscilloscope display.
Analog channel, math, or reference waveforms can be saved to a reference
waveform file on a USB storage device. You can recall a reference waveform file
from a USB storage device into one of the reference waveform locations.
To save a waveform to a reference waveform location
1 Press the [Ref] key to turn on reference waveforms.
2 In the Reference Waveform Menu, press the Display Ref softkey and turn the
Entry knob to select the desired reference waveform location you want to
To Next Page
Loading...
Need help?
General
