Repair Guide 6
Keysight N1913/1914A Service Guide 105
Required Torque Values for Fasteners
Required tools and torque values for fasteners are listed below:
Item Description/Default Range of values
Fit rear panel GPIB standoffs 9/32” socket 2.37 Nm
Fit rear panel Trig In/Out connectors
Special tooling kit
(N1912-61807)
2.37 Nm
Fit rear panel recorder output connectors 7/16” spanner 2.37 Nm
Attach main board to clamshell T20 screwdriver 2.37 Nm
Attach PPMC assemblies to main board T8 screwdriver 0.56 Nm
Fit calibrator semi-rigid, both ends (Option 003) 5/16” spanner 1.02 Nm
Attach earth wires (nut) 9/32” socket 1.02 Nm
Attach earth wires (screw) T20 screwdriver 2.37 Nm
Attach top clamshell to bottom clamshell T20 screwdriver 2.37 Nm
Fit sensor connector Circlip pliers
Fit PSU/PSU safety cover T10 screwdriver 2.37 Nm
Fit display to display support molding T6 screwdriver 0.56 Nm
Fit calibrator to display support molding T6 screwdriver 0.34 Nm
Fit display interface board to inverter board T6 screwdriver 0.56 Nm
To Next Page
Loading...
