Keysight N1914A - Figure 6-10 Remove the Front Panel; Figure 6-11 Remove PPMC

Repair Guide 6
Keysight N1913/1914A Service Guide 111
Remove the front panel (Figure 6-10). Carefully lift and remove
the front panel assembly.
Figure 6-10 Remove the front panel
– Disconnect PPMC cables (Figure 6-11). Disconnect the
service connector cable from the PPMC assembly.
Disconnect the ribbon cable from the main board, whilst
leaving it connected to the PPMC assembly.
– Remove the PPMC assembly (Figure 6-11). Use the T8 Torx
screwdriver bit to remove the screws attaching the DAP and
PPMC assemblies to the main board. Carefully remove the
PPMC assembly by lifting the end closest to the DAP
assembly. Carefully remove each DAP assembly by lifting the
end closest to the rear panel.
Figure 6-11 Remove PPMC
Instructions Visual