Keysight N777-C Series Tunable Laser Family User’s Guide 69
N777-C Web User Interface Reference 4
Figure 28 Repeat Modes
How to Set the Maximum Power for the Sweep Range?
Pressing Set Pmax/Sweep sets the power to the maximum for the
selected sweep range. Pressing Set Pmax/Sweep ensures the power will
be constant for the whole sweep.
How to Perform a Sweep?
There are three sweep modes:
• Stepped - which dwells at wavelengths that are separated by a certain
step size,
• Continuous - which sweeps continually at the speed you set, and
• Manual - which you can run each step manually.
You cannot turn the laser off by pressing the Active hardkey on the
Tunable Laser front panel, while a wavelength sweep is running.
You can press Stop and, then, press the Active hardkey on the Tunable
Laser front panel, to turn off the laser.
To Next Page
Loading...
Need help?
General
