Keysight N9320B - Page 96

Command Reference
DANalyse Subsystem
90
IFBW
DANalyse:AM|FM:IFBWidth <freq>
DANalyse:AM|FM:IFBWidth?
Specifies the IF bandwidth value in demodulation measurement.
*RST: 1.2 MHz
Key access:
> AM/FM Modulation Analysis > IFBW
IFBW Auto
DANalyse:AM|FM:IFBWidth:AUTO OFF|ON|0|1
DANalyse:AM|FM:IFBWidth:AUTO?
Sets the IF bandwidth coupled automatically or manually.
*RST: 1.2 MHz
Key access:
> AM/FM Modulation Analysis > IFBW
Equivalent LPF
DANalyse:AM|FM:EQLPfilter
AUTO|OFF|6|20|60|200|600|2000
DANalyse:AM|FM:EQLPfilter?
Specifies the Equivalent low pass filter in a known state as below:
off - turns off the EqLPF.
Auto - selects the EqLPF automatically from the available EqLPF
lists.
*RST: Auto (200 kHz)
Key access:
> AM/FM Modulation Analysis > EqLPF
MODE
MODE
MODE