105
Command Reference
Trigger Subsystem
RF Burst Trigger Slope
:TRIGger[:SEQuence]:RFBurst:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:RFBurst:SLOPe?
This command activates the trigger condition that allows the
next sweep to start when the external RF signal (connected
to RF IN connector) passes RF burst trigger level.
Before you set the trigger slope, The external trigger source
must be selected using the command
:TRIGger[:SEQuence]:SOURce RF Burst.
*RST: Positive
Key access: Shift > Sweep > Trigger > RF Burst > Trigger Slop
Periodic Timer Period
:TRIGger[:SEQuence]:FRAMe:PERiod <time>
:TRIGger[:SEQuence]:FRAMe:PERiod?
Specifies periodic timer period under gate sweep mode.
Example: :TRIGger:FRAMe:PERiod 10ms
Key access: Shift > Sweep > Gated Sweep > Gate Source >Periodic Timer, then
Timer Setup > Period
Periodic Timer Offset
:TRIGger[:SEQuence]:FRAMe:OFFSet <time>
:TRIGger[:SEQuence]:FRAMe:OFFSet?
Specifies periodic timer offset under gate sweep mode.
Example: :TRIGger:FRAMe:OFFSet 10ms
Key access: Shift > Sweep > Gated Sweep > Gate Source >Periodic Timer, then
Timer Setup > Offset
To Next Page
Loading...
Need help?
General
