Keysight N9322C User Manual

Command Reference
Calculate Subsystem
90
Calculate Subsystem
This subsystem is used to perform post- acquisition data
processing. In effect, the collection of new data triggers the
CALCulate subsystem. In this instrument, the primary
functions in this subsystem are markers and limits.
Limit Line Subsection
Limit lines can be defined for your measurement. You can
then have the instrument compare the data to your defined
limits and indicate a pass/fail condition.
Type of Limit Line
:CALCulate:LLINe[1]:TYPE UPPer|LOWer
:CALCulate:LLINe[1]:TYPE?
Sets a limit line to be either an upper or lower type limit
line. An upper line will be used as the maximum allowable
value when comparing with the data.
Example: :CALCulate:LLINe:TYPE UPPer
Key access: Shift > Limit > Limit 1 > Limit Type
Limit Line State
:CALCulate:LLINe[1]|2:STATe OFF|ON|0|1
:CALCulate:LLINe[1]|2:STATe?
Toggles the limit line function between on and off.
Key access: Shift > Limit > Limit 1> Limit Line On/Off
Fixed/Relative Limit
:CALCulate:LLINe:CMODe FIXed|RELative
:CALCulate:LLINe:CMODe?
Toggles the limit line mode between fixed and relative.
Key access: Shift > Limit > Limits Fixed/Rel

Keysight N9322C Specifications

General

Brand	Keysight
Model	N9322C
Category	Measuring Instruments
Language	English