199
Command Reference
Power Meter Option Subsystem
Power Meter Option Subsystem
The Power Meter Option Subsystem provides you the SCPI
command reference for the Power Meter function. Use the
command :INSTrument POWmeter to access this
subsystem.
Option PWM or PWP is required to enable this function.
Option PWM supports Keysight U2000 series USB average
power sensor, and Option PWP supports Keysight U2020 X
series peak power sensor.
Power Sensor Zeroing
:CALibration[1]:ZERO:ONCE
This command perform power sensor zeroing operation.
Example: :CAL1:ZERO:ONCE
Key access: Meas > Zeroing > Zeroing
Zeroing Type
:CALibration[1]:ZERO:TYPE EXTernal|INTernal
:CALibration[1]:ZERO:TYPE?
This command toggles the zeroing type between external
type and internal type. U2020 X series peak power sensor
only support internal zeroing type.
Example: :CALibration1:ZERO:TYPE EXTernal
Key access: Meas > Zeroing > Zero Type
Power Meter Sweep State
[:SENSe]:SWEep:STATe RUN|PAUSe
[:SENSe]:SWEep:STATe?
This command toggles power meter sweep state between run
and pause.
Example: :SWEep:STATe PAUSe
To Next Page
Loading...
