Command Reference
Tracking Generator Option Subsystem
212
Tracking Generator Option Subsystem
The Tracking Generator Option Subsystem provides you the
SCPI command reference for the Tracking Generator
funciton.Use the command :INSTrument TGENerator to
access this subsystem.
Option TG7 is required to enable this function.
Tracking Generator Output Amplitude
:SOURce:POWer[:LEVel][:IMMediate][:AMPLitude] <value>
:SOURce:POWer[:LEVel][:IMMediate][:AMPLitude]?
*RST: –20 dBm
Range: 0 to –30 dBm
Example: :SOURce:POWer -10 dBm
Key access: Meas > Amplitude
Tracking Generator Amplitude On/Off
:OUTPut[:STATe] OFF|ON|0|1
:OUTPut[:STATe]?
Use this command to turn/off the tracking generator output.
*RST: Off
Key access: Meas > Amplitude On Off
Tracking Generator Amplitude Offset
:SOURce:CORRection:OFFSet <value>
:SOURce:CORRection:OFFSet?
This command sets the amplitude offset of the tracking
generator output. This command is valid after tracking
generator is enabled.
*RST: 0 dB
Range: 0 to –30 dBm
Example: :SOURce:CORRection:OFFSet -10 dB
Key access: Meas > Amptd Offset
To Next Page
Loading...
