Keysight N9322C - Reflection Measurement Option Subsystem

133
Command Reference
Reflection Measurement Option Subsystem
Reflection Measurement Option Subsystem
The Reflection Measurement Option Subsystem provides you
the SCPI command reference for the reflection measurement
function. Use the command :INSTrument CAT to access
this subsystem.
Option RM7 and TG7 are required to enable the reflection
measurement function.
Reflection Measurement Type
[:SENSe]:CAT REFLection|OPCLoss|DTF
[:SENSe]:CAT?
Toggles the reflection measurement mode between Reflection
Measurement, One Port Insertion LossMeasurement and
Distance to Fault Measurement.
Range: REFLection, OPCLoss, DTF
Example: :CAT OPCL
Key access: Meas > Meas > Reflection Measurement / One Port Insertion Loss/
Distance To Fault
Reflection Measurement Calibration Type
[:SENSe]:CAT:CALibrate:TYPE FULL|SELected
[:SENSe]:CAT:CALibrate:TYPE?
This command toggles calibration type between full
frequency range calibration and selected frequency range
calibration.
Range: FULL, SELected
Example: :CAT:CALibrate:TYPE FULL
Key access: Freq > Cal Type