Keysight N9322C - Page 129

121
Command Reference
Power Measurement Subsystem
SEM Offset Sweep Time
[:SENSe]:SEMask:OFFSet:LIST:SWEeptime
<time>,<time>,<time>,<time>,<time>
[:SENSe]:SEMask:OFFSet:LIST:SWEeptime?
Use this command to specify the related sweep time of offset
channels in SEM measurement. The unit for the time in this
command is second.
[:SENSe]:SEMask:OFFSet:LIST:SWEeptime:AUTO
OFF|ON|0|1,...
[:SENSe]:SEMask:OFFSet:LIST:SWEeptime:AUTO?
Use this command to turn on/off automatically setting of
sweep time of reference channels in SEM measurement.
Example: :SENSe:SEMask:OFFSet:LIST:SWEeptime
10,10,10,10,10
Key access: Meas > SEM > Offset/Limit > Sweep Time
SEM Offset Abs StartAmpt
[:SENSe]:SEMask:OFFSet:LIST:STARt:ABSolute
<ampl>,<ampl>,<ampl>,<ampl>,<ampl>
[:SENSe]:SEMask:OFFSet:LIST:STARt:ABSolute?
Use this command to specify the start frequency amplitude
of offset channel absolute limit mask in SEM measurement.
Before use this command, the fail mask type should be set
to “Absolute” or “Abs AND Rel” or “Abs OR Rel”.
Example: SENSe:SEMask:OFFSet:LIST:STARt:ABSolute -14,
-14,-15,-20,-20
Key access: Meas > SEM > Offset/Limit > More 1 of 3 > Abs StratAmpt