Keysight N9322C - Page 183

175
Command Reference
Demodulation Option Subsystem
FM Detector
[:SENSe]:AMA:DEMod:DETector[:FUNCtion]
PPK|NPK|PNPK|RMS
[:SENSe]:AMA:DEMod:DETector[:FUNCtion]?
Use this command to specify the detector in FM
demodulation analysis.
Example: :AMA:DEMod:DETector PPK
Key access: Meas > Detector
FM Detector PeakHold
[:SENSe]:AMA:DEMod:DETector[:FUNCtion]:PEAKhold
OFF|ON|0|1
[:SENSe]:AMA:DEMod:DETector[:FUNCtion]:PEAKhold?
Use this command to turn on/off peak hold state of detector.
Example: :AMA:DEMod:DETector:PEAKhold ON
Key access: Meas > Detector > PeakHold
FM IF Bandwidth
:SENSe]:AMA:IFBWidth
1.2MHz|960kHz|600kHz|480kHz|300kHz|240kHz|120kHz
|96kHz|60kHz
[:SENSe]:AMA:IFBWidth?
This command specifies IF bandwidth of FM demodulation
analysis.
Range: 1.2 MHz, 960 kHz, 600 kHz, 480 kHz, 300 kHz, 240 kHz, 120
kHz, 96 kHz, 60 kHz
Example: :AMA:IFBWidth 96kHz
[:SENSe]:AMA:IFBWidth:AUTO OFF|ON|0|1
[:SENSe]:AMA:IFBWidth:AUTO?
This command turns on/off IF bandwidth of IF demodulation
analysis.
Example: :AMA:IFBWidth:AUTO ON
Key access: Meas > IFBW