Keysight N9322C - Page 24

Programming Fundamentals
Parameters in Commands
18
Variable Parameters
<ampl>,
<rel_ampl>
The <ampl> (amplitude) parameter and the <rel_ampl>
(relative amplitude) parameter consist of a rational number
followed by optional units. Acceptable units for <ampl>
include: V, mV, V, dBm, dBmV, dBuV, Watts, W. <rel_ampl>
units are given in dB.
<file_name> A file name parameter is the name of your file, is not used
in the SCPI command string.
<freq> A frequency parameter is a positive rational number
followed by optional units. The default unit is Hz. Acceptable
units include: Hz, kHz, MHz, GHz.
<integer> There are no units associated with an integer parameter.
<number> A number parameter is a member of the set of positive or
negative intriguers and including zero. Fractional numbers
are included in the number parameter. There are no units
associated with a number parameter.
<percent> A percent parameter is a rational number between 0 and
100, with no units.
<rel_power> A relative power parameter is a positive rational number
followed by optional units. The default units are dB.
Acceptable units are dB only.
<string> A string parameter includes a series of alpha numeric
characters.
<time> A time parameter is a rational number followed by optional
units. The default units are seconds. Acceptable units
include: S, MS, US.