Keysight P937xA PXIe Service Guide 27
Tests, Adjustments, and Troubleshooting
Before You Begin
Before You Begin
Before checking, verifying, or adjusting the analyzer, refer to the following
paragraphs to:
— get the required Service Test equipment
— make sure the operating environment is within its requirements
— make sure that proper electrostatic discharge (ESD) protection is provided
— make sure the analyzer has warmed up properly to achieve system stability
— review the principles of connector care
Get the Hardware Required for your GPIB Instruments
The hardware required to connect your GPIB instruments to the network
analyzer depends on the type of controller you use.
— Because the P937xA uses a remote controller, you need a GPIB card for the
PC.
Verify the Operating Environment
For Operating Environment information, refer to the online Data Sheet at
http://literature.cdn.keysight.com/litweb/5992-2765EN.pdf.
Protect Against Electrostatic Discharge (ESD)
For information on protecting against electrostatic discharge (ESD), refer to the
online Startup Guide at
http://literature.cdn.keysight.com/litweb/pdf/P9370-90001.pdf.
Allow the Analyzer to Warm Up
Review the Principles of Connector Care
For online information on connector care, go to
http://na.support.keysight.com/pna/connectorcare/Connector_Care.htm.
To achieve the maximum system stability, allow the network analyzer to
warm up for at least 15 minutes.
To Next Page
Loading...
Need help?
General
