Features of your vehicle
365
Windows
Automatic reversal (For Type B)
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resis
-
tance and will stop upward movement.
The window will then lower approxi
-
mately 11.8 inches (30 cm) to allow the
object to be cleared.
If the window detects the resistance
while the power window switch is pulled
up continuously, the window will stop
upward movement then lower approxi
-
mately 1 inch (2.5 cm).
If the power window switch is pulled up
continuously again within 5 seconds
after the window is lowered by the auto
-
matic window reversal feature, the auto
-
matic window reversal will not operate.
The automatic reversal feature for the
window is only active when the "auto up"
feature is used by fully pulling up the
switch. The automatic reverse feature
will not operate if the window is raised
using the halfway position on the power
window switch.
Always check for obstructions before
raising any window to avoid injuries or
vehicle damage. If an object less than
0.16 of an inch (4 mm) in diameter is
caught between the window glass and
the upper window channel, the auto
-
matic reverse window may not detect
the resistance and will not stop and
reverse direction.
The automatic reverse feature doesn't
activate while resetting power window
system. Make sure body parts or other
objects are safely out of the way before
closing the windows to avoid injuries.
Do not install any accessories in the
vehicle that extend into the open win
-
dow area. Such objects could prevent
the automatic reverse feature from
functioning.
Power window lock button
The driver can disable the power win
-
dow switches on the rear passengers'
doors by pressing the power window
lock button to the lock position
(pressed).
When the power window lock button is
pressed:
僅 The driver's master control can oper
-
ate the front passenger's power win
-
dow and the rear passengers' power
windows.
To Next Page
Loading...
