Driver assistance system
387
Safe Exit Warning (SEW)
Blind-Spot Collision-Avoidance Assist
may not operate properly when driv
-
ing where the heights of the lanes are
different. Blind-Spot Collision-Avoid
-
ance Assist may not detect the vehicle
on a road with different lane heights.
Always pay attention to road and driv
-
ing conditions while driving.
僅 When you are towing a trailer or
another vehicle, make sure that you
turn off Blind-Spot Collision-Avoid
-
ance Assist.
僅 Blind-Spot Collision-Avoidance Assist
may not operate normally if interfered
by strong electromagnetic waves.
僅 Blind-Spot Collision-Avoidance Assist
may not operate for approximately 15
seconds after the vehicle is started, or
the front view camera or rear corner
radars are initialized.
This device complies with Part 15
of the FCC rules.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interfer
-
ence received, including interference
that may cause undesired operation.
Safe Exit Warning (SEW) (if
equipped)
After the vehicle stops, when an
approaching vehicle from the rear area
is detected as soon as a passenger
opens a door, Safe Exit Warning will
warn the driver with a warning message
and an audible warning to help prevent
a collision.
Warning timing may vary depending on
the speed of the approaching vehicle.
Detecting sensor
Rear corner radar
Refer to the picture above for the
detailed location of the detecting sen
-
sors.
For more details on the precautions of
the rear corner radars, refer to "Blind-
Spot Collision-Avoidance Assist (BCA) (if
equipped)" on page 7-28.
To Next Page
Loading...
