Electric vehicle guide
101
EV menu
2. Connect to the power outlet located in
the base of the rear seat with the EV
button in the ON position.
3. Check the operation status through
the front indicator of the power outlet.
僅Blue: Standby
僅 Red: No power supply even though
the power outlet is connected
僅 Green: Normal power supply
through the normal connection of
the power outlet.
LCD display messages
V2L has ended. Battery level has
reached the set value
A:
V2L has ended. Battery level has
reached the set value
When the high voltage battery level
reaches the discharging limit set level,
the V2L will stop and the warning will be
displayed. If you want to use the V2L
continuously, make the discharging limit
set level lower than the present battery
level.
V2L stopped due to excessive
power use
A:
V2L stopped due to excessive
power use
If you use an electrical appliance that
exceeds the maximum power output the
vehicle can supply, it will stop working
and display a warning message. Make
sure that the total power consumption of
your electrical appliances does not
exceed the V2L maximum power output.
V2L conditions not met
A:
V2L conditions not met
If V2L is interrupted for any of the fol
-
lowing reasons, a warning message is
displayed.
僅 V2L connector switch off
僅 V2L connector overheating
僅 Opening the charging door while
using the V2L interior outlet
Make sure there are no problems with
the V2L connector and the vehicle
indoor outlet.
To Next Page
Loading...
