Driver assistance system
1267
Remote Smart Parking Assist (RSPA)
Rear ultrasonic sensors (Type A)
Rear ultrasonic sensors (Type B - GT-
Line)
Rear ultrasonic sensors (Type C - GT)
Refer to the picture above for the
detailed location of the detecting sen
-
sors.
僅 Never disassemble the detecting sen
-
sor or sensor assembly, or apply any
impact on it.
僅 If the detecting sensor have been
replaced or repaired, have your vehi
-
cle inspected by an authorized Kia
dealer.
僅Remote Smart Parking Assist may
malfunction if the vehicle bumper
height or ultrasonic sensor installation
has been modified or damaged. Any
non-factory installed equipment or
accessories may also interfere with
the sensor performance.
僅 When the ultrasonic sensor is frozen
or stained with snow, dirt, or water,
the sensor may not operate until the
stains are removed using a soft cloth.
僅 Do not push, scratch or strike the
ultrasonic sensor. Sensor damage
could occur.
僅 Do not spray the ultrasonic sensors or
its surrounding area directly with a
high pressure washer.
Remote Smart Parking Assist set
-
tings
Warning Methods
A:
Driver Assistance
1 Warning Methods
2 Warning Volume
Warning Methods can be set when the
vehicle is in ON position.
僅
Warning Volume
: Select
Setup
→
Vehicle
→
Driver Assistance
→
Warning Methods
→
Warning Vol
-
ume
on the infotainment system, and
adjust the warning volume.
Even if you set the warning volume to
0, Warning volume will keep its vol
-
ume in 1. (If steering wheel vibration
equipped)
僅Ensure that
Warning Methods
you
have set may apply to the Warning
Methods of other driver assistance
systems.
To Next Page
Loading...
