What to do in an emergency
168
If you have a flat tire (with Tire Mobility Kit)
3. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
4. Adjust the tire inflation pressure to the
cold tire recommended pressure as
indicated on the vehicle's placard or
tire inflation pressure label located on
the driver's side center pillar outer
panel. (In this owner's manual, refer to
"Tires and wheels" on page 10-4.)
僅
To increase the inflation pres
-
sure
, switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
The pressure gauge may show higher
than actual reading when the compres
-
sor is running. To get an accurate tire
reading, the compressor needs to be
turned off.
Do not let the compressor run for more
than 10 minutes; otherwise, the device
may overheat and be damaged.
僅
To reduce the inflation pressure
,
press the valve on the compressor.
Tire Pressure Sensor
When you use the Tire Mobility Kit with a
sealant that is not approved by Kia, the
tire pressure sensors may be damaged
by sealant. The sealant on the tire pres
-
sure sensor and wheel should be
removed when you replace the tire with
a new one and the tire pressure sensors
should be inspected at an authorized
dealer.
Technical data
The specifications of the Tire Mobility Kit
are as follows.
* Sealant and spare parts can be
obtained and replaced at an autho
-
rized vehicle or tire dealer. Empty seal
-
ant bottles may be disposed of at
home. Liquid residue from the sealant
should be disposed of by your vehicle
or tire dealer or in accordance with
local waste disposal regulations.
System Voltage DC 12 V
Working Voltage DC 12 V
Amperage rating max. 15 A
Suitable for use at
temperatures
-22 to 158 °F
-30 to 70 °C
Max. working pressure 101 psi (7 bar)
Size
Compressor
5.9 x 5.1 x 2.4 inches
(150 x 130 x 60 mm)
Sealant bottle
4.5 x 3.4 ø inches
(115.3 x 87.3 ø mm)
Compressor
weight
1.36 lbs.
(620 g)
Sealant volume 24.4 cu. in. (400 ml)
To Next Page
Loading...
