Chapter 2: Front panel programming
P/N 3102351-EN • REV 005 • ISS 28DEC18 73
option the cursor is on. Also, the options you select are preserved and will be displayed the
next time you auto program.
6. When you have finished, press Enter.
The panel begins auto programming and displays the number of devices on the system. If
you have more than one loop, the device counts are per loop. If you previously
programmed the panel, The system displays the number of old and new devices.
7. Press Enter to continue.
Auto programming continues based on the settings you made above.
8. When prompted, program the options you selected using the procedures that follow. For
example, if you are using a dialer, auto programming requires you to program specific
dialer options.
9. When auto programming is complete, the system displays the banner screen.
Labeling devices
If you set the Label Devices auto programming option to Yes, follow these steps to label the
devices.
To label devices:
1. Next to “Device,” enter the device number to be labeled.
2. Enter a text label for the device (two lines of 20 characters). The default label is “Loop X
Device XXX.”
3. Press Enter to save the label and go to the next number of the device.
Note: Pressing the Enter button saves the current label, and then goes to the next
available device, so that you can quickly go to each device and label it.
4. Enter a text label for the device (two lines of 20 characters).
5. Repeat steps 3 and 4 until all devices are labeled.
6. When you have finished labeling, place the cursor in the device number field, and then
press the Cancel button to reopen the previous menu. Continue with the next auto
programming option.
See “Programming relay and sounder detector bases” on page 94.
Labeling zones
If you set the Label Zones auto programming option to Yes, follow these steps to label zones.
To label zones:
1. Next to “Zone,” enter the number of the zone to be labeled.
To Next Page
Loading...
