8.4. Oil and grease
Only use the manufacturer’s authorised
mineral hydraulic oils and greases.
The attachment may be operated with industry-standard mineral oils
according to the information in the operating instructions for the carrier.
Because of the functional test completed by the manufacturer, residual material
of the following hydraulic oil may still be present in the attachment:
HLP46 according to DIN 51524 Part 2 / ISO VG 46
In order to be able to use the attachment on ecologically sensitive terrain or in
protected areas, the manufacturer authorises operation with the following quickly
biologically degradeable hydraulic oil:
HEES according to ISO 15380 or OECD 301 B
Possible damage due to using non-homogeneous hydraulic oil.
• Do not mix hydraulic oils of differing standards under any circumstances.
• In case of doubt regarding the specification or mixture, replace
the hydraulic oil completely.
• The proportion of foreign oil must not exceed 2%.
• Hydraulic oils should be analysed every 500 operating hours
to avoid a premature oil change.
Observe the information in the operating instructions for the carrier.
Lubricate greasing points and surfaces with the following multi-purpose grease:
EP2 according to DIN 51825: KP2K-20 and ISO / DIS 6743-9: ISO L-XBCHB 2
Grease nipples as described in the Maintenance - Overview of greasing
Transmission oil recommendation and first filling:
Alternatively, the following transmission oil may also be used:
ISO VG 1000 per DIN 51517-3, Q8 Schumann G 1000
In special cases, use the following fluid grease:
Alvania EP 0 high-performance fluid grease DIN 51502
GP0G-30 consistency class 0 (DIN 51818)
For the filling quantity for the transmission lubricant, refer to the chapter
8.5. Disposal
Observe country-specific and regional disposal directives.
After proper shut down and removal of hydraulic oil and grease residues, the
attachment can be disassembled and the materials recycled.
To Next Page
